Matlab is unable to detect the sampling frequency of Audio Interface
4 次查看(过去 30 天)
显示 更早的评论
I have an ASIO audio interface. It is running at 48000Hz. When I check rate using playrec('getDevices'), I see the default sampling rate as 44100Hz. I tried changing the sampling frequency on the device, however Matlab reads the same 44100 Hz.
Is there any way to resolve this issue?
0 个评论
回答(1 个)
Daniel Shub
2011-12-9
One of the points of playrec, and other port audio interfaces, is to bypass the Microsoft Windows mixer. You need to set the sample rate with playrec, not with the Microsoft Windows mixer.
6 个评论
Daniel Shub
2011-12-13
I am not sure if a loop back will let you validate the sample rate. I am pretty sure you need either a known signal or a known recording. If it is the start latency that you are worried about, I think the psychtoolbox port audio implementation is the lowest latency implementation that I have seen.
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Simulation, Tuning, and Visualization 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!