清空筛选条件
清空筛选条件

How to start multiple analog output on Ni daq device?

6 次查看（过去 30 天）
Simon
Simon 2015-9-4
评论： Simon 2015-9-8
Hello
I'm trying to use Ni daq device to output multiple signals. The signals are not started at same time, instead, some of them are sine wave signals which run for several seconds, while others are single pulses which triggered by external input. The sine wave signals keeps outputting throughout the session, while whenever there's a trigger signal, the ni daq device must give a short output. I tried many ways to fulfill this function. Anyway, the problem is that I can't output other signals when the sine wave signal is outputting. Matlab warns the device has been reserved and the new output signal can't be start. Is there any way I can use to solve this problem?
Thank you

请先登录，再回答此问题。

回答（1 个）

Tushar Sinha
Tushar Sinha 2015-9-8
Hi Simon
There are some NI devices which allow you to do only one hardware-timed analog output task.
You can refer to the link below for more information on the same: http://digital.ni.com/public.nsf/allkb/2C45C3DC484FF730862570E7007CCBD4
The above link also talks about the "Error -50103 - specified resource is reserved" error which is analogous to the warning you are getting.
Thanks, Tushar

类别

在 Help Center 和 File Exchange 中查找有关 Analog Input and Output 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by