Using PMSM model for electric vehicle simulation

2015 9 14
1 个回答
更新时间：2017 11 11
71 次查看（30 天）

0 个投票

I'm using a PMSM model (the one in the AC6 example) for an electric vehicle and i want to simulate the motor ME1115. But there is no place in the model to change the power. So how exactly can i change that?

请先登录，再回答此问题。

回答（1 个）

ahmad yasser
ahmad yasser 2017-11-11

0 个投票

Did you find how to set the power rating of the motor?

1 个评论
显示 -1更早的评论 隐藏 -1更早的评论

Alexandre Bitencourt
编辑：Alexandre Bitencourt 2017-11-11
You control the electrical power by inductances Ld and Lq, sadly my motor's datasheet didn't have this information, so i had to keep changing those values until find a good result. Keep in mind that Lq should be a little bit greater then Ld (look at the motor equation) and the controller must have the same Ld and Lq values, if he uses it.

请先登录，再进行评论。

社区

更多回答在  Power Electronics Control

类别

在 帮助中心 和 File Exchange 中查找有关 Green Vehicles 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by