xPC target using UEI PD2-MF-64-3M/12H

1 次查看（过去 30 天）
Nir
Nir 2011-12-26
I'm relatively new to xPC. I have UEI PD2-MF-64-3M/12H as data aquisition board in my target PC, and I've built a simple model to grab the data and send it to the host (I'm using Matlab 2010a).
The model is running fine, but all the data is 0. Even when I connect a fixed input voltage, I don't see any data.
It looks like the board is simple not enabled.
I'd appreciate some help on whaty can I do to find out what I'm doing wrong.

请先登录，再回答此问题。

回答（1 个）

Gordon Weast
Gordon Weast 2012-2-10
Contact Tech support and provide a sample model that shows the problem. It could be just a setup problem, but it's hard to tell without seeing the model and all the settings.

类别

在 Help Center 和 File Exchange 中查找有关 Multicore Processor Targets 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by