external mode is suuported by arduino uno also?
1 次查看(过去 30 天)
显示 更早的评论
sir/mam i created a simple model to read from analoginput and display on scope... when i run it on external mode on arduino uno board it show me this error....suggest me possible settings or some solution
Current code generation target for model 'm3' is either not configured for or does not support external mode. In the Code Generation > Interface pane of Configuration Parameters dialog, select Interface option to be "External Mode" to enable external mode for targets that support it
0 个评论
回答(2 个)
Madhu Govindarajan
2015-10-20
External mode is not supported by Arduino Uno - http://www.mathworks.com/hardware-support/arduino-simulink.html
In this link you can see that interactive tuning and monitoring is not supported for Uno boards. One suggestion is to create a Simulink model that transmits the information you need serially and then use MATLAB serial commands to bring in the information to MATLAB (I understand it is a bad alternative and I apologize for the same).
0 个评论
Walter Roberson
2015-10-19
It is supported by the Mega 2560 and by the Due; see http://www.mathworks.com/help/supportpkg/arduino/ug/tune-and-monitor-model-running-on-arduino-mega-2560-hardware.html
The Mega ADK might also be supported; see http://www.mathworks.com/help/supportpkg/arduino/examples/communicating-with-arduino-hardware.html
I do not find any explicit statement that External Mode is not supported on other boards.
2 个评论
Walter Roberson
2017-2-26
External mode for Leonardo is also available, and Mega ADK is confirmed, bringing the list to Due, Uno, Leonardo, Mega 2560, and Mega ADK.
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Setup and Configuration 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!