failed to receive a control packet from the FPGA target

2 次查看（过去 30 天）
Medhat Elsayed
Medhat Elsayed 2015-10-30
回答： Jazmin 2019-9-13
Hi,
I am trying to perform the simulink example (fil_pid) using MATLAB 2014b, Vivado 2014.1, and Xilinx VC707 board. I performed all the steps successfully as shown in the figures below.
However, when I replace the controller and try to simulate the design, it gives me this error message:
I tried to check the connection with the FPGA (using ping command), and I found that it is working well. And the FPGA programming file is downloaded successfully.
So, I do not know what is really the problem.
Thanks.

请先登录，再回答此问题。

回答（1 个）

Jazmin
Jazmin 2019-9-13
Hello, did you solve the problem, I found the same mistake, I'musing Atlys Spartan 6 development board... Please, need help

类别

在 Help Center 和 File Exchange 中查找有关 FPGA, ASIC, and SoC Development 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by