How to create a matrix from a vector using specified values

Question

John Harry 2015-11-3

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/252587-how-to-create-a-matrix-from-a-vector-using-specified-values

评论： Geoff Hayes 2015-11-3

I have a column of hip angle data from a treadmill walking trial (roughly 1 min) with a length of 12113 elements. I have identified heel strikes in a separate vector of data that has a length of 55 elements (55 heel strikes). I want to create a matrix where each column is hip angle data between successive elements of the heel strike vector (each column represents one stride). I have tried for loops and while loops, but nothing has worked.

I was able to create a single column of data representing one stride (using the commands below), but I need to get all 54 strides into a matrix. Do any of you have suggestions to how I can create the matrix?

i = 1;
LHIP(:,1) = LHIP_Angles(LHEE_Strikes(i):LHEE_Strikes(i+1));

Thanks in advance.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Geoff Hayes 2015-11-3

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/252587-how-to-create-a-matrix-from-a-vector-using-specified-values#answer_198367

在 MATLAB Online 中打开

John - since it is unlikely that each stride has the same number of hip angles, you may want to use a cell array to store the data. Try the following

 LHIP = cell(1,length(LHEE_Strikes)-1);
 for k=1:length(LHEE_Strikes)-1
     LHIP{k} = LHIP_Angles(LHEE_Strikes(k):LHEE_Strikes(k+1));
 end

3 个评论
显示 1更早的评论隐藏 1更早的评论

John Harry 2015-11-3

I wanted to let you know that I figured out how to normalize the cell array (created with your code, Geoff) and normalized it to 101 data points and then converted to a matrix.

Thanks again.