Deploying Simulink code to hardware using Matlab's command line

11 次查看（过去 30 天）
Damiano Varagnolo
Damiano Varagnolo 2015-12-10
评论： Victor Bayer 2021-12-18
Hello, is it possible to deploy some .slx code to hardware using some opportune Matlab command? I have been succesfully launching an external-mode simulation using "open_system('my.slx')" and "set_param('my.slx', 'SimulationCommand', 'start')", but I did not find a command that deploys the .slx to hardware.
Any hints? Thanks in advance!

请先登录，再回答此问题。

回答（1 个）

Vaibhav Awale
Vaibhav Awale 2016-1-14
Hi,
You can refer to following documentation links for command line functions to deploy simulink models:
Configuring Model from Command Line
Build, Load and Run
Hope this helps.
Regards,
Vaibhav
  1 个评论
Victor Bayer
Victor Bayer 2021-12-18
the build Load Run link seems to be out of date. Could you please provide a new one? I am trying to deploy a Simulink model from the command line on a raspberry pi and do not know how.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Raspberry Pi Hardware 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by