SIMULINK -HDL CONVERSION ERROR
显示 更早的评论
I am using MATLAB 2015 A version .I have the following simulink model .
When i run it I have no problem in getting the o/p but as I try to convert it HDL code using Generate HDL
I get the following errors and warnings .
I need to convert this to HDL and test it on SPARTAN 6 fpga board .
采纳的回答
Tim McBrayer
2015-12-16
1 个投票
You have picked three blocks that are not supported for HDL code generation, as mentioned in the error messages. In addition you are connecting them with matrices, which is also clearly mentioned as not supported.
You might want to try using the Gamma Corrector block out of the Vision HDL Toolbox instead of the Gamma Correction block from the Computer Vision System Toolbox. This Vision HDL block accepts and generates a pixel stream as opposed to passing the entire image in parallel. This hardware-appropriate interface will also remove the issue of matrix signals from your model.
更多回答（1 个）
Bharath Venkataraman
2015-12-16
0 个投票
Vision HDL Toolbox was released in R2015a. You may need to ask your administrator to see if you have access to this Toolbox.
类别
在 帮助中心 和 File Exchange 中查找有关 HDL Code Generation and Deployment 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
