Why do I get an "failed to connect error" when trying to connect my Lego Mindstorms EV3 robot with Simulink?
6 次查看(过去 30 天)
显示 更早的评论
MathWorks Support Team
2016-2-15
编辑: MathWorks Support Team
2024-4-18
When trying to deploy my Simulink model to my Lego Mindstorms EV3 robot I get the following error message:
ERROR: The call to realtime_make_rtw_hook, during the after_make hook generated the following error:
Failed to connect to EV3 (192.168.179.21). Please check your network settings.
The build process will terminate as a result.
Caused by:
Failed to connect to EV3 (XXX.XXX.XXX.XX). Please check your network settings.
Component: Simulink | Category: Model error
Where XXX.XXX.XXX.XX is the IP of my EV3. The behavior started only recently. Connecting to the brick in MATLAB works fine. The firmware version is V1.09H.
采纳的回答
MathWorks Support Team
2024-4-18
编辑:MathWorks Support Team
2024-4-18
In the firmware version V1.09H, SSH and telnet are blocked by Lego. The interface Simulink uses to connect to the brick relies on these two types of connections while the interface used in MATLAB does not.
In order to be able to connect to the brick, use an older Firmware version, for example 1.03. Please contact Lego support on how you can access older versions of firmware:
Note that the firmware versions 1.06, 1.07 and 1.08 are also known to work with the Simulink support package for LEGO MINDSTORMS EV3 without any known issues. However the support package is tested thoroughly only with 1.03 version of the firmware.
Previous firmware releases can be difficult to obtain, so a fix has been released to allow compatibility with
. Note that
for this version.
0 个评论
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 LEGO MINDSTORMS EV3 Hardware 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!