The time for adding a channel
显示 更早的评论
Hi,
When I declare the device and AO channel using DAQ toolbox, it takes quite a bit of time to do it. Is that normal?
%%Create the new obj
clear all;clc;
t1=cputime;
ao = analogoutput('nidaq','Dev1');
% Create channel
chan = addchannel(ao,0);
t2=cputime-t1
I have used the cputime to calculate the time, it was 11.75s. It's pretty long. Anything causes this time problem? Is that possible to fix?
thanks, Kay
回答（1 个）
Manisha
2012-1-31
Hi Kay,
The long time is because of the
clear all
command you have in the starting. This commands removes all functions from memory and therefore when you execute
analogoutput
it has to load all the drivers and functions needed. So if you try to run your script again without the clear all, you will see a substantial decrease in the time taken.
Hope that helps,
Manisha
类别
在 帮助中心 和 File Exchange 中查找有关 Data Acquisition Toolbox Supported Hardware 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
