How to start Simulink model on Raspberry Pi automatically on startup?

Question

Ahmed Desoky 2016-3-6

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/271795-how-to-start-simulink-model-on-raspberry-pi-automatically-on-startup

编辑： satwant singh 2017-3-30

I have built a Simulink model consisting of three blocks (Pulse generator + Data Type Conversion + GPIO Write) to flash a LED.

I loaded it onto the board, and the model ran normally from the computer in both normal and external modes. The LED was flashing. I stopped the Simulink model and unplugged the power and ethernet cables.

The Simulink model is converted into an executable that runs on the Raspberry Pi board. Typically, the executable is saved in the `/home/pi/Simulink_model_name_rtt/MW/Simulink_model_name` directory. The name of the executable is the same as the Simulink model name.

I ran the operating system of the Raspberry Pi via VNC viewer to execute the Simulink model that exists in MW folder. But the LED wasn't flashing.

Terminal from VNC viewer.

I went to Terminal from PuTTY to execute the Simulink model that exists in the MW folder. It returned the error:

Error setting GPIO pin direction.

Terminal from Putty.

*I want to run the Simulink model* that has been loaded onto the Raspberry Pi board (after Raspberry Pi booting and startup) without running the Simulink model again on the computer via Ethernet connection.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

satwant singh 2017-3-30

编辑：satwant singh 2017-3-30

Is internet connection is mandatory while interconnecting respberry pi with simulink?

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Mark McBroom 2016-3-19

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/271795-how-to-start-simulink-model-on-raspberry-pi-automatically-on-startup#answer_214256

you need yo use sudo because the model is accessing pi hardware

sudo ./LED_Test

2 个评论
显示无隐藏无

wasted 2016-7-29

Hello Mark!

The Model on my Pi doesn't start with this command.

The Terminal displays:"Starting The Model", but the Model doesn't start and the Pi doesn't seem to be responding afterwards, because I am not able to enter any new commands..

Would be nice to be hearing from you!

wasted 2016-7-29

Solved it myself:

It is important to press: Deploy to Hardware in Simulink GUI. Pressing "Run" only does not create a standalone application on the raspberry pi (model 2 B). At least that's my experience..

请先登录，再进行评论。