How to generate deadband between two complimentary pulses of inverter.

19 次查看（过去 30 天）
Uvesh Sipai
Uvesh Sipai 2016-3-15
评论： Arifin 2024-6-20
There should be a proper dead-band between two pulses of switches of one lag of inverter, to avoid shoot through. Dead-band will make rising edge of each pulse delay by defined time. We can generate dead-band by use of analog circuit and set it's value by design of R-C network in hardware. But is there way to make a complimentary pulses with proper microsecond dead-band in matlab simulink??

请先登录，再回答此问题。

回答（1 个）

Dr. Pemendra Kumar Pardhi
Hi,
In MATLAB Simulink, deadband can be provided by using dead zone or on/off delay (continuous) or on/off delay (discrete).
If any third party support like C2000 hardware support package and its EPWM block is used then there are also provisions available to provide a deadband time.
Thanks,
Pemendra
  1 个评论
Arifin
Arifin 2024-6-20
Hi,
how to generate deadband smaller than Ts ?
I am working with MPC for control MPC.
the output MPC connected to GPIO Output.
however i need to add deadband between MPC and GPIO.
Ts = 50e-6. and i would like to generate deadband 1e-6.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Linear Plant Specification 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by