Audio Processing
显示 更早的评论
Can someone tell me how to use low pass filter to limit the frequency of an audio signal to <6000hz? inorder to remove higher frequency components..
采纳的回答
Wayne King
2012-1-31
Hi Kathik, You have left out an important bit of information and that is the sampling frequency. I'll assume that is 44.1 kHz in this example.
In what follows, Hd1 is an FIR equiripple design and H2 is an IIR Butterworth design. I'll use 50 dB of attenuation.
d = fdesign.lowpass('Fp,Fst,Ap,Ast',6000,6200,0.5,50,44100);
Hd1 = design(d);
Hd2 = design(d,'butter');
To apply the filter to data, use
output = filter(Hd1,input);
1 个评论
PRIYANK SHAH
2012-2-4
Hi Wayne king and kartik,
can u suggest how to find out fft of the audio signal for 44.1 KHz sampling freq, before and after the same above low pass filter to check that ma filter is correct or not!!
Thank you.
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Simulation, Tuning, and Visualization 的更多信息
2012-1-31
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
