清空筛选条件
清空筛选条件

Error Using mzxml read

9 次查看（过去 30 天）
Katie
Katie 2016-4-7
评论： 天琪 李 2022-9-1
Hello:
I am using MATLAB 2015a.
I converted a set of Thermo.raw files into mzXML using msconvert.gui (Proteowizard). The files are from an Thermo Orbitrap Velos, and contain MS2 data.
I am trying to read them into MATLAB using mzxmlread.m and I am getting the following error
>> testscript
Starting to parse document...
Building mzXML substructure...
Building scan substructure...
Error using typecast
The first input must contain a multiple of 8 elements to convert from int8 (8 bits) to double (64 bits).
Error in mzxmlread>processPeaks (line 699)
mzpeaks = swapbytes(typecast(peaks,'double'));
Error in mzxmlread/parseScan (line 555)
out.(elementNameScan)(countScan+1).peaks.mz = processPeaks(b64.decode(data),64);
Error in mzxmlread (line 420)
parseScan;
Error in testscript (line 1)
mzXMLStruct = mzxmlread('SampleA_Search1.mzXML');
I have seen this question two other times on MATLAB central- I commented on those as well, but none have been answered. any feedback would be really appreciated.
Thank you
Katie
  1 个评论
Yuqing Ye
Yuqing Ye 2017-5-25
Hi,
I have the same question with you. If you have solved this, would you please tell me the solution?
Thank you
Yuqing Ye

请先登录，再进行评论。

请先登录，再回答此问题。

回答（4 个）

Yuqing Ye
Yuqing Ye 2017-5-25
Hi,
I have solved it!
When using msconvert you should choose these options as the picture below shows.
-Yuqing Ye
Arthur Goldsipe
Arthur Goldsipe 2016-4-8
Hi,
I believe the mzXML file is invalid. mzxmlread could give a more helpful error message, but the error occurs when the peaks data for a run is invalid. Perhaps msconvert did not correctly encode the data.
-Arthur
Luuk van Oosten
Luuk van Oosten 2016-4-11
编辑：Luuk van Oosten 2016-4-11
Dear Katie,
The problem might occur due to the fact that your mzXML file is improperly generated, as Arthur Goldspie already remarked.
Note that MATLAB is only able to handle mzXML files that are conform the 2.1 specifications or earlier. Try to generate your mzXML file with an older version and try again... I believe that you can find those versions somewhere over here.
That might solve it.
Jingxuan Li
Jingxuan Li 2017-10-25
Hi Yuqing et al, I followed your instruction in generating the file. However, I got error as attached---may I ask if you have seen this before, and how did you deal with it? Thanks!
Jay

类别

在 Help Center 和 File Exchange 中查找有关 Bioinformatics Toolbox 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by