Connecting Resistor and DC Voltage Source

24 次查看（过去 30 天）
Michael Gregory
Michael Gregory 2016-5-5
评论： KUSUMAKAR 2024-4-23
Hello, I am trying to connect a DC Voltage Source to four resistors and those resistors to a current measurement and then display this value. Even though the DC Voltage Source and the resistors are all from Simscape, they won't connect. It comes up with a red dotted line and a purple circle. The Current measurement also wont connect to the resistors. I've tried using PS->S and S-> PS converters but this doesn't help either. Any help you can give would be greatly appreciated. Thanks

请先登录，再回答此问题。

回答（1 个）

Sebastian Castro
Sebastian Castro 2016-5-6
Make sure both of these blocks come from the same block library.
Unfortunately, there are "DC Voltage Source" and "Current Measurement" blocks in both Simscape Foundation and in Simscape Power Systems Specialized Technology libraries.
I'd suggest going to the Simscape > Foundation > Electrical library and grabbing all the blocks from there.
BTW: If you're using one of the latest versions, you can easily tell where they're from because the Simscape blocks will be colored blue whereas the Power Systems ones are not colored.
- Sebastian
  5 个评论
显示 3更早的评论
Mahmoud Gamea
Mahmoud Gamea 2021-5-15
you can use "ps-simulink" and "simulink-ps" converters for that purpose.
And for a lot of cases I think you will also need a voltage sensor block
.

请先登录，再进行评论。

社区

更多回答在  Power Electronics Control

类别

在 Help Center 和 File Exchange 中查找有关 Electrical Sensors 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by