Please support me to solve this problem because the simulation stopped after 3.76 sec from starting by this error..?
3 次查看(过去 30 天)
显示 更早的评论
An error occurred while running the simulation and the simulation was terminated
Simulink cannot solve the algebraic loop containing 'untitled/PV Array/Diode Rsh/Product5' at time 3.7605000000000004 using the TrustRegion-based algorithm due to one of the following reasons: the model is ill-defined i.e., the system equations do not have a solution; or the nonlinear equation solver failed to converge due to numerical issues. To rule out solver convergence as the cause of this error, either a) switch to LineSearch-based algorithm using set_param('untitled','AlgebraicLoopSolver','LineSearch') b) reducing the ode45 solver RelTol parameter so that the solver takes smaller time steps. If the error persists in spite of the above changes, then the model is likely ill-defined and requires modification.
1 个评论
Walter Roberson
2016-5-8
What happened when you used the command
set_param('untitled','AlgebraicLoopSolver','LineSearch')
and then re-ran?
回答(1 个)
tret retret
2020-1-17
I get the message :
what does it mean?
Warning: Changing property 'AlgebraicLoopSolver' is not allowed
2 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Linearization 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!