error while running simulation!!!

M Gokul

2016 6 10

0 个回答

3 次查看（30 天）

0 个投票

Im getting following error while running a control system simulation Stopping simulation. There may be a singularity in the solution. If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances) What should I do?

2 个评论
显示无隐藏无

Torsten 2016-6-10

编辑：Torsten 2016-6-10

First you should look at the results up to the time when the solver stops and see whether they are reasonable. Usually, such an error message indicates that the solution gets unphysical.

Best wishes

Torsten.