How to stop a function? Simulink.
显示 更早的评论
Hello,
This is what I want to do, I am working on simulink, I have a function (M-file), I have one input, if this input is equal to "1" the M-file start and when the input change to "0", I want to stop this M-file (and reset all the values) until the input change again to 1 and start the excecution as the first time.
Some how the "IF" block of simulink only make the change but the M-file continue being executed.
I can not use the pause command because Its stop all the simulation And I only want to stop the execution of this M-file.
I hope u understand me, I wait for your help. Thanks.
回答（1 个）
Kaustubha Govind
2012-2-15
0 个投票
I think you need to out your M-file inside an Enabled Subsystem and use your input as the control signal for the subsystem, so that your M-file is executed only when the subsystem is enabled.
类别
在 帮助中心 和 File Exchange 中查找有关 Simulink 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
