red dotted wire problem in simulink

20 次查看（过去 30 天）
prasoon purwar
prasoon purwar 2012-2-20
编辑： chelladurai c 2020-8-11
hello , please tell me how to make the dotted red wire to solid black wire in simulink while implementing a circuit, is there any procedure to follow

请先登录，再回答此问题。

回答（2 个）

Kaustubha Govind
Kaustubha Govind 2012-2-21
You are probably attempting to connect a Simulink signal to a physical signal, or vice versa. These are signals in two different domains, and cannot be directly connected. See point#1 in Guy's answer here: http://www.mathworks.com/matlabcentral/answers/14998-simulink-signal-and-physical-signal
  3 个评论
显示 1更早的评论
Kaustubha Govind
Kaustubha Govind 2012-2-22
The AC Source blocks are from SimPowerSystems (which use regular Simulink signal connections), whereas the Resistor is from the SimScape library (physical modeling).
chelladurai c
chelladurai c 2020-8-11
编辑：chelladurai c 2020-8-11
how i can connect Ac source with Current measurement ( red dotted line is coming ) and transformer

请先登录，再进行评论。

prasoon purwar
prasoon purwar 2012-2-21
take series RLC from simpowersys blockset instead of resisistor.circuit will be ok then. we cannot use low power blocks with simpower system blocksets in Simulink ,that's it.

类别

在 Help Center 和 File Exchange 中查找有关 Electrical Block Libraries 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by