How do I connect a Joint spring-damper to a prismatic joint which is further connected to a mass in SimMechanics, without letting two masses disconnect.?
4 次查看(过去 30 天)
显示 更早的评论
Hello, I am trying to model a system that consisting of mass(which is in motion in x direction)- (spring &damper in x direction) - mass - (spring and damper in z direction) using simmechanics. While putting a joint spring and damper on a prismatic, it disconnects and the masses moves at separate velocity. Is this a normal situation ? I have been trying to fix things a lot. Now, suppose I use a revolute joint the masses stay connected, but not with the prismatic joint.
2 个评论
Ari
2017-6-30
Can you provide a rough sketch of how the massses and SMDs are connected along with which is the x and z directions?
回答(1 个)
Steve Miller
2019-4-3
Hi - without the model, it is very hard to give you a good suggestion.
Some things it could be:
- Springs were too weak, and gravity pulls them far apart.
- Your did not properly attach the mechanism to ground
If you share the model we may be able to give better advice.
--Steve
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Assembly 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!