spectrogram comparisons

3 次查看（过去 30 天）
Matt
Matt 2012-2-22
I'm wanting to run a couple of spectrograms for analysis: one of raw sound and one of filtered sound. When I do this, the intensity of the spectrograms is different for each one because the filtered sound now has a smaller range of frequencies, therefore a smaller intensity field. Is there any way to equalize the intensity of spectrograms so that when I colormap them they are at least closer in color than they are now, without just opening a colormap editor? For example, the raw sound on the default colormap is mostly yellow, with a small red bar at the bottom. When I filter that sound for the frequencies I want, now the whole spectrogram is mostly red with a darker red bar at the bottom. Is there an easy way to adjust these intensities so that they match a little bit closer?

请先登录，再回答此问题。

采纳的回答

nanren888
nanren888 2012-2-23
Perhaps the default colour scaling is set by the maximum value found. It might be as simple as scaling by that?
I guess that if the peak to average ratio of the two is wildly different, the plots may still look quite different.

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Orange 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by