Simscape: thermal liquid pump
显示 更早的评论
Hello!
I have the oil flow rate data in the centrifugal pump (for the transformer's cooling system).
But I haven't found any useful pumps in which I can use this data, only pressure and mass flow sources.
Is there any pump blocks, that could be handy?
回答（1 个）
Yifeng Tang
2022-7-1
1 个投票
In newer versions of Simscape Fluids, there are more pump modules available.
In general, the pump can be modeled by using look up tables of rpm, pressure ratio/difference, and flowrate. One can set up pressure sensors at the two ends of the ideal flow source, send the pressure signal to a LUT that will give you the flowrate, which can be then sent to the source block.
3 个评论
Nikolay Panasetsky
2022-7-1
Andreas
2022-7-12
@Yifeng Tang like this:
Yifeng Tang
2022-7-12
I usually do this:
where delta_P drives the flow rate. But I think your way, flow rate drives delta_P, would work as well. Any observation you could share?
Couple notes:
- adding another dimension of pump RPM allows you to turn off and adjust the pump output.
- If your MATLAB version allows, use isothermal liquid instead of hydraulics. https://www.mathworks.com/help/physmod/simscape/ug/upgrading-hydraulic-models-to-use-isothermal-liquid-blocks.html
类别
在 帮助中心 和 File Exchange 中查找有关 Simscape Fluids 的更多信息
2016-8-22
2022-7-12
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
