How to Stop the Execution of Simulink in response to a Signal

5 次查看（过去 30 天）
Teo Samuel
Teo Samuel 2012-2-24
Hi all,
I am currently dealing with real time control using MATLAB. The system I have is a host computer, a target processor and my hardware.
There are two limit switches installed on my hardware. So, I would like to design a way that whenever the limit switch is activated,a signal will be sent back to the target processor and eventually to the simulink in the host computer that control the entire process. This signal will thus stop the execution of the simulink automatically(like clicking the stop tab " II " in the simulink).
Can I know how to achieve this? Please help this is quite urgent. Thank you very much.
Regards

请先登录，再回答此问题。

回答（1 个）

Kaustubha Govind
Kaustubha Govind 2012-2-24
Try the Stop Simulation block. It stops the simulation when its input is non-zero.

类别

在 Help Center 和 File Exchange 中查找有关 Multicore Processor Targets 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by