清空筛选条件
清空筛选条件

Scope with same inputs don't show same values SIMULINK

4 次查看（过去 30 天）
j_solar
j_solar 2012-2-27
In SIMULINK
I have the problem that when I transfer a variable from the main system to a subsytem and look at them both with a scope, the one from the main system shows all the results (from 0-17520) and the one in the subsytem only from 12000-17520.
I am not sure if this is a problem with the scope or if the values are being affected, thus affecting my results. If it is not clear I can add some pictures.
ty

请先登录，再回答此问题。

采纳的回答

j_solar
j_solar 2012-2-27
Ok found it. In the scope there is an option that limits the number of points to be plotted. Change it to 17520 run it again and voila!
  1 个评论
K E
K E 2012-2-27
Can you unaccept your answer? Then you might get some Simulink expert to read your question.

请先登录，再进行评论。

更多回答（1 个）

j_solar
j_solar 2012-2-27
Looking more into it, it happens to all the variables. And it shows exactly 5000 values, so it could be something like the data transfer between subsytems is limited to 5000?

类别

在 Help Center 和 File Exchange 中查找有关 Schedule Model Components 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by