simscape and simpower sysystem
显示 更早的评论
I want to connect inverter output to variable resistor.Two blocks are in simpowersystem and simscape respectivy. how to connect? please help me...
采纳的回答
cr
2012-3-4
0 个投票
It isn't clear from the question what exactly you mean, but in case you want to use blocks from these two domains in the same model, please note that Simpowersystems (SPS) and SimScape(SS) are different domains and blocks from these domains cannot be connected with those in other domains directly. Information exchange can be done by using converter blocks (ps-s and s-ps). E.g. you want to change resistance based on a voltage signal in SPS. Feed this signal to variable resistor via s-ps block of SS.
更多回答（2 个）
zia kansi
2014-9-3
0 个投票
hey every body...i have also the same problem i am unable to connect my inverter voltage output to the motor block(made by me not built in block). the S-ps and PS-s converter do not work. so any body please is there any other solution?? please help me.. if there is some other alternative so please tell me...thanks
rez
2015-11-7
0 个投票
how do i use on mathlab/simulink a point on voltage wave for varing the firing angle with added resistance to reduce transformer inrush current at the energisation? thank you
类别
在 帮助中心 和 File Exchange 中查找有关 Foundation and Custom Domains 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
