Hi all:
I'm trying to read from an IMU through COM port on a PC104, in Simulink Real-Time. Since there's no existing block specified for this PC104, the only applicable blocks are those under Simulink Real-Time/RS232/MainBoard/Baseboard Serial Internal blocks/.
Problem is the setup block there requires a "Base Address" (shown below) which is not clearly explained in its help doc.
My question is: is this "Base Address" the address of the COM port? For example, the COM port on my PC104 has address 3F8-3FF, so I will need to use 3F8 as the "Base Address"?
Another question is about the FIFO mode: the IMU I'm using does not seem to have a FIFO, I did notice that there was a "1 deep" FIFO mode, does it essentially mean "No FIFO"?
Any help would be greatly appreciated. Thanks for your time!
