Why the 48 pulse GTO-Based STATCOM doesn't work effectively on my model?

1 次查看（过去 30 天）
Eric Chen
Eric Chen 2016-10-5
回答： Joel Van Sickel 2023-5-2
This is my observed bus voltage in per unit before installing STATCOM.
However, bus voltage after installing STATCOM only increase reactive power level since there is still the same ripple. How can I eliminate the ripple on voltage? The setting in STATCOM is the same as follows: https://www.mathworks.com/help/physmod/sps/powersys/ug/gto-based-statcom.html
Thank you very much!

请先登录，再回答此问题。

回答（1 个）

Joel Van Sickel
Joel Van Sickel 2023-5-2
This is an effort to clean up Matlab Answers. Unfortunately, this response is likely to late to be of help to this question:
For this type of question, a model would need to be shared to better understand why a certain approach might not be working.

类别

在 Help Center 和 File Exchange 中查找有关 Power Converters 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by