Dear all,
I have the 2 following problems with using simmechanics :
i)I am trying to use simmechanics to act with a sinusoïdal force on a prismatic joint. I use the following configuration.
Unfortunately, when I run the simulation the mass just mooves in one direction and don't oscillate around the zero position. Does someone have an explanation.
ii)When I try to actuate the motion and not the force, I get the error:
_
"In the dynamically coupled component containing Prismatic Joint Prismatic_Joint, there are fewer joint primitive degrees of freedom with automatically computed force or torque (0) than with motion from inputs (1). The prescribed motion trajectories in this component may not be achievable. Solve this problem by reducing the number of joint primitives with motion from inputs or increasing the number of joint primitives with automatically computed force or torque. Resolve this issue in order to simulate the model."_
I don't understand why I get this error
Thanks for all the help you can provide.
