How to pause the simulation with a command line

2016 10 10
1 个回答
更新时间：2016 10 12
6 次查看（30 天）

0 个投票

It's probably simple but i can not find the solution.
When a code is running, you can pause it by clicking the pause button in the ribbon above (two blue lines).
Afterwards you can continue the simulation by clicking on the continue button (at the same spot).
I want to do the same action by commanding it in the script (at a certain command line).
When I type 'pause' in the command line, the simulation will pause but it will continue when I press any key. I want to be able to change some variables while it is paused and then press the continue button to continue the simulation.
.
kind regards, K

1 个评论
显示 -1更早的评论 隐藏 -1更早的评论

KSSV
KSSV 2016-10-10
I think using pause is an bad idea..instead you change them in the code itself.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Preethi
Preethi 2016-10-10

0 个投票

hi,
you can use breakpoints at places where you want to pause, you can change the values and then continue.

2 个评论
显示 无 隐藏 无

K VdB
K VdB 2016-10-10
hi, thanks for the answer
I know about the break points. I am working with them currently The problem is that the breakpoints disappear when you close and reopen the program. And because I have a lot of breakpoints it's quite a chore going through the script and resetting them.
greets
Preethi
Preethi 2016-10-12
hi,
once you set breakpoints and save the file the breakpoints will be retained. Which version are you using?

请先登录，再进行评论。

类别

在 帮助中心 和 File Exchange 中查找有关 Entering Commands 的更多信息

标签

提问:

K VdB
K VdB
2016-10-10

评论：

Preethi
Preethi
2016-10-12

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by