problem with mcde R2010a

13 次查看（过去 30 天）
Giu
Giu 2012-2-29
回答： Jon 2014-2-4
Hi, I have a Matlab ver 2010a, and I'm trying to start with Matlab parallel computing, after the installation I start the Admincenter, add a host, and start with the Test connectivity. Afterwards, I obtain an error in the MDCE column, "status unavailable".
I have seen other post and they suggest to install mdce with the admin privileges and start it, but when I go to the folder (in which there is admincenter as well), there isn't the file called mdce but only mdce_def. Is it possible? Or, in your opinion an error during the installation is occurred.

请先登录，再回答此问题。

回答（3 个）

Julian
Julian 2012-6-21
I have exactly the same problem
Jason Ross
Jason Ross 2012-6-21
It sounds like your installations are not complete. Did you install the MDCE feature when you installed MATLAB? It's separate from the Parallel Computing Toolbox. With Admin Center, you should set up the MDCS, start job manager, start workers and that should be about it.
Also, FWIW, mdce.bat should be there and used to install a service on Windows, e.g.
mdce install
mdce start
Installation support can help you set up MDCS and get it running, too.
Jon
Jon 2014-2-4
try to install the "network version" rather than the "standard alone version"

类别

在 Help Center 和 File Exchange 中查找有关 Introduction to Installation and Licensing 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by