Why am I unable to complete installation of MATLAB R2016b when installing from the 2 ISO images I downloaded?

11 次查看（过去 30 天）
MathWorks Support Team
编辑： MathWorks Support Team 2018-12-12
I have downloaded and mounted both of the ISO images required to install MATLAB R2016b on an offline machine. During installation, I receive the following message:
Eject DVD 1 and insert DVD 2 to continue
How can I proceed with installation?

请先登录，再回答此问题。

采纳的回答

MathWorks Support Team
编辑：MathWorks Support Team 2018-12-12
This error will occur if the mounted ISO for DVD2 cannot be found at the mount point that MATLAB is searching for it.
To resolve this error, un-mount all MATLAB ISOs you currently have mounted on your computer through your mounting utility of choice, then mount *only *the DVD2 ISO. (Do not close out of the MATLAB installer while un-mounting/mounting your ISOs.) You should now be able to proceed with the MATLAB installer.
Additionally, if you are unable to mount the other disk you can alternatively create a single installation package to install MATLAB. Please refer to the article below on this process:
How can I obtain a single installation package for MATLAB with the ISOs (Merge the ISO Images)?
https://www.mathworks.com/matlabcentral/answers/320198

更多回答（2 个）

hopei helpedu
hopei helpedu 2016-10-16
U should see 2 new disc while u re installing setup since u have 2 iso file. When u get that warning, eject the disk1 by right click&eject option; then go (device manager)/storage/(disk management) and then find your 2nd iso file disc, right click on it and select "change drive letter and paths" option, finally change your drive letter to one early belong to your disc 1. Now you can continue to installation. Sorry if the description is a bit messy :) (eg. While u re installing u ll see disc1:F & disc2:G; eject ur :F disc and change label of disc2 G to F)
Muhammad Awais Manzoor
After downloading iso formats of both cd. cd1(around 7 GB) and cd2(arounf 2.5 GB), do the following steps: 1). Unmount CD1 and install that.
2). then it would ask you to eject cd1 and insert CD2 at this point you have to open My Computer and from there you have to eject CD1 by right clicking on it.(but rememeber the drive name)
3). Now unmount CD2(but be careful because the drive name for CD2 must match the drive name of CD1).
4). Now press OK on the pop up which was asking for inserting CD2.
Done. Now it should be installed.
That worked for me and i hope that would work for everyone.

类别

在 Help Center 和 File Exchange 中查找有关 Introduction to Installation and Licensing 的更多信息

标签

尚未输入任何标签。

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by