getsnapshot does not give clear image
2 次查看(过去 30 天)
显示 更早的评论
I wrote a code for image acquisition,when i get a live video using ' videoinput' function i get clear live video. but when i use getsnapshot function to get captured image from live video, i dont get clear image. plz give me solution of this. thank you.
imaqhwinfo
info = imaqhwinfo('coreco')
info.DeviceInfo
%dev_info = imaqhwinfo('demo',info.DeviceInfo.DeviceID);
vid=videoinput('winvideo',1,'YUY2_640x480');
preview(vid)
frame = getsnapshot(vid);
image(frame);
delete(vid);
1 个评论
采纳的回答
vish
2012-3-3
Your image snapshot is in YUY2 format. What you need to do is convert your YUY2 image to RGB. You can find one on file exchange section.
2 个评论
Image Analyst
2012-3-3
If that's the problem there should be a rgb mode that shows up in the winvideo category of the hardware browser when he runs imaqtool. He should pick one of the RGB modes.
更多回答(1 个)
Image Analyst
2012-3-3
Define "clear". It should look fairly similar but maybe noisier. A single snapshot will always appear noisier than a video stream. Also be aware that some cameras have two different sets of settings, one for video mode and one for snapshot mode. You could be adjusting the camera to look good under video but then when you switch to snapshot mode, it's using a different set of settings. This could be what's happening if it's more than simply a noisier image. Consult Coreco for how their cameras work. Also, you might want to use the Coreco driver built for their camera, if they have one, rather than the generic winvideo driver.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Image Acquisition Support Packages for Hardware Adaptors (Generic Video Interface) 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!