When best to use 1 and 2 DOF PID

4 次查看（过去 30 天）
bethel o
bethel o 2016-11-10
回答： Arkadiy Turevskiy 2016-12-7
I am not sure of the difference between normal single input and the 2 DOF PID controller in simulink. I noticed that the 2 DOF PID block accepts the reference (r) and the measurement(y) separately but under the hood it computes the error=r-y which is what the normal PID accepts as a single input. They both seem to be doing the same thing. I have a control problem where the reference point changes as well as the measurement signal. How will the 2 DOF PID controller make a difference to my control problem compared to the normal single input PID block? Or what problem does the 2 DOF PID controller solve compared with the normal single input?

请先登录，再回答此问题。

回答（1 个）

Arkadiy Turevskiy
Arkadiy Turevskiy 2016-12-7
The first opening paragraphs of this doc page might help. This example will also help.

类别

在 Help Center 和 File Exchange 中查找有关 Real-Time PID Autotuning 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by