Missing Signal Target Scope

2 次查看（过去 30 天）
Roman Weiss
Roman Weiss 2016-12-6
回答： Hari Desanur 2016-12-12
Hello,
as described above a signal is not displayed numerically on the target pc running simulink realtime (R2015b). Others are displayed in the same scope.
If I try to read out the signal by command prompt (Matlab R2015b):
>> tg.getsignalidsfromlabel('dLambda1')
ans = 335
>> tg.getsignal(335)
Error using xpctarget.xpc/getsignal TargetPC1: Invalid Signal index
Additionally the signal index is higher than the number of signals. I would be a happy for a possible solution / short explanation what is going wrong here.
Thank you in advance.
Best regards Roman

请先登录，再回答此问题。

回答（1 个）

Hari Desanur
Hari Desanur 2016-12-12
You must make sure that the signal which you are trying to monitor is not virtual signal or a virtual bus. You may have to add a 'Gain' block to monitor that signal -
http://www.mathworks.com/help/xpc/ug/nonobservable-signals.html

类别

在 Help Center 和 File Exchange 中查找有关 Scopes and Data Logging 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by