Simulation of common source circuit.

2 次查看（过去 30 天）
Taishi Sawauchi
Taishi Sawauchi 2016-12-8
回答： Ricardo A. Baila 2016-12-8
I want to simulate common source circuit in Simulink. But I think the waveform shown in scope seems not enough accurate. Could you tell me how to change the accuracy(simulation step?).
I attached model.mdl

请先登录，再回答此问题。

回答（1 个）

Ricardo A. Baila
Ricardo A. Baila 2016-12-8
Surely. To reduce the time step of your solver, click on the bottom right (where it says what solver is being used), and then click on the little gear that appears. When the configuration panel appears, you can click on "Additional options" in order to show the option related with the definition, including the maximum and minimum step size (as a personal reference and for not too short simulations, you can try to put the max step size as 0.1 seconds for example - if it doesn't refine your results enough, try with 0.01)

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by