Tx and Rx length

2012 3 8
1 个回答
更新时间：2020 7 23
46 次查看（30 天）

0 个投票

I ran a model in simulink and I received error message that Tx and Rx length must be the same. Is there any suggested solution to this problem?

请先登录，再回答此问题。

回答（1 个）

Kaustubha Govind
Kaustubha Govind 2012-3-8

0 个投票

The error appears to be fairly self-explanatory, but perhaps you should specify if you're running one of the demo models, or if it is something you made - which block does the error point to, and how you are unable to fix the symptom that the message points to.

3 个评论
显示 1更早的评论 隐藏 1更早的评论

Kayode ojetunde
Kayode ojetunde 2012-3-8
It was an DTFM modulation model and the Tx block consist of Bernoulli Binary as source, Modulator placeholder, Raise Cosine Filter, Resample, Frequency offset(0),is data was transmitted directly from source and transmission out put after offset. Rx (De-Modulator placeholder was used). First I received that signal miss match error. Now to cal BER is telling me Tx and Rx length.
Kaustubha Govind
Kaustubha Govind 2012-3-9
Make sure that the two inputs to the BER block have the same length.
yogesh sahu
yogesh sahu 2020-7-23
How??

请先登录，再进行评论。

类别

在 帮助中心 和 File Exchange 中查找有关 DTMF 的更多信息

产品

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by