How to refer the figure name in matlab
55 次查看(过去 30 天)
显示 更早的评论
Hi, I would like to define a figure and then for that specific figure do some things. Foe example: I would like to vreat a digure say:
h1 = figure('units','normalized','outerposition',[0 0 1 1]);
and then I want for h1 to do for example:
subplot(1,3,1)
plot(N_vec,1./Err(N_vec),sprintf('*%c',colconds(loop)),'LineWidth',5)
hold on
plot(N_vec,1./ErrPV(N_vec),sprintf('*%c',colconds(loop+2)),'LineWidth',5)
hold on
xlabel('Population size','fontsize',20)
ylabel('Error^-2 ','fontsize',20)
legend('OLE','PV','OLE shuffled','PV shuffled','Location','northwest')
The thing is that from loop reasons, h1 is defined far from the above lines. and is not the current figure handel. So I want the above lines to refer specifically for h1. somethong like:
subplot('h1',1,3,1)
plot('h1',N_vec,1./Err(N_vec),sprintf('*%c',colconds(loop)),'LineWidth',5)
hold on
plot('h1',N_vec,1./ErrPV(N_vec),sprintf('*%c',colconds(loop+2)),'LineWidth',5)
hold on
xlabel('h1','Population size','fontsize',20)
ylabel('h1','Error^-2 ','fontsize',20)
legend('h1','OLE','PV','OLE shuffled','PV shuffled','Location','northwest')
But matlab gives error whenever i try to add the name h1 in the specific commands for the figure...
how do I refer the figure handel when I actully want to use it?
Thanks!!
0 个评论
采纳的回答
更多回答(2 个)
Preethi
2017-1-2
hhello,
hope this helps. it sets figure with h1 handle as current figure.
set(groot,'CurrentFigure',h1);
0 个评论
Niels
2017-1-2
Hi,JazzMusic
did u try
figure(h1)
to set h1 the current figure before u use subplot?
figure(h1)
subplot(1,3,1)
plot(N_vec,1./Err(N_vec),sprintf('*%c',colconds(loop)),'LineWidth',5)
hold on
...
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Subplots 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!