Simscape Powersystems Asynchronous machine initialization code

2017 1 3
1 个回答
回答已采纳
更新时间：2017 1 7
5 次查看（30 天）

0 个投票

Hi, I am trying to run the initialization command for the Asynchronous machine (SI units) block manually but I am not getting any value in 'SM' struct. Are the values in SM struct available for viewing or are they blocked? I understand the 'AsynchronousMachineInit' code is a private file and cannot be viewed. But I was expecting to at least see the results using it's initialization code to verify and validate the block outputs. The values I am using for Nominal Parameters are base apparent power in VA found using formula (sqrt(3)*line voltage*nominal current), line voltage and nominal frequency. The code runs fine with the values I input, but the SM struct shows up empty. Please suggest a solution so that I can verify and validate the block outputs. For reference I am using Matlab 2016b. Thanks.

请先登录，再回答此问题。

 采纳的回答

Brandon Eidson
Brandon Eidson 2017-1-6

0 个投票

Hey Karanjot, I have confirmed that the "SM" structure, like the "AsynchronousMachineInit" function, is private and cannot be viewed. The machine's terminal initial conditions are the only ones that are viewable. The machine's calculated internal initial conditions (e.g., flux leakage) which are stored in the "SM" structure are kept hidden.
It is not entirely clear to me what you mean by you trying to "verify and validate the block outputs". Because you have a valid Software Maintenance Service with MathWorks, I would encourage you to contact MathWorks Technical Support with more details about your workflow and desired used case to see if we can help find a solution.

1 个评论
显示 -1更早的评论 隐藏 -1更早的评论

Karanjot Singh
Karanjot Singh 2017-1-7
Hi Brandon, Thanks a lot for your help and answer. I would contact Mathworks technical support for further help. The problem is that I am not sure if the torque value coming out as output from asynchronous machine (SI unit) is correct. As the calculations are done in per unit using VA (Volt-Ampere) system for power and there is no input given with regards to power factor. The base torque is different from rated torque. If the output torque has been converted to N-m using base torque, then I need to convert the torque output to per unit again and multiply by rated torque to get the actual value. The parameter SM.Tb2 is used in mechanical model for conversion of output torque from per unit to N-m. That is only one of the parameters causing me doubts. Thanks again. I appreciate the help.

请先登录，再进行评论。

更多回答（0 个）

类别

在 帮助中心 和 File Exchange 中查找有关 Simscape Electrical 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by