How can I include new signal into WaveFormGenerator Simulink block from a script?

Question

Javier 2017-1-17

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/320804-how-can-i-include-new-signal-into-waveformgenerator-simulink-block-from-a-script

关闭： MATLAB Answer Bot 2021-8-20

Hello,

I would like to add a new signals to the list of my current signal for the WaveFormGenerator block.I have already generated a string ( signal below) that should be placed under the signals list, this is the following

signal = step('StepTime',1e-05,'InitialValue',1,'FinalValue',0.9)+step('StepTime',1e-05,'InitialValue',0.9,'FinalValue',0.8)

I have tried to use gcb along with set_param for that block, but I don't know which parameter to address to set my signal on the WaveFormGenerator list

Any advise?

Thanks in advance,

Regards!

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

此问题已关闭。

Answer 1

Chinmayi Lanka 2017-1-20

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/320804-how-can-i-include-new-signal-into-waveformgenerator-simulink-block-from-a-script#answer_251378

编辑：Chinmayi Lanka 2017-1-20

I don't think that you can set a value for the 'Waveform Definition' field from the command line. As per the following documentation, there is no command-line parameter listed for 'Waveform Definition':

https://www.mathworks.com/help/simulink/slref/waveformgenerator.html#buvhsry-5

Also, the block specific parameters for the 'Waveform generation' block does not have any command-line parameter listed for 'Waveform Definition': http://www.mathworks.com/help/releases/R2015b/simulink/slref/block-specific-parameters.html