How to switch simulink blocks using a parameter?

2 次查看（过去 30 天）
Martin
Martin 2017-1-18
评论： Martin 2017-1-26
Hello,
in my Simulinkmodel I want to test different controller blocks. In my "Input Generation"-block I implemented 4 different controllers. Everytime I want to test another controller, I have to remove the input and output connections and make new connections for the new block by hand which is quite annyoing. Is there a way to to this with a parameter? Say if some constant c is equal to 1, I want Controller 1 to be connected to the input and output ports of "input generation" and so on. Thanks for your help.

请先登录，再回答此问题。

采纳的回答

Jordan Ross
Jordan Ross 2017-1-24
Hello Martin,
What you are going to want to use is actually is a "variant subsystem". The following documentation page discusses what they are:
http://www.mathworks.com/help/simulink/slref/variantsubsystem.html
However, of more interest to you is the following documentation page which contains an example of modeling different variants of controllers:
http://www.mathworks.com/help/simulink/ug/define-and-configure-variants.html

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Modeling 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by