清空筛选条件
清空筛选条件

How to close Simulink model subsystems

7 次查看（过去 30 天）
Noam G
Noam G 2012-3-13
回答： Pablo Romero 2015-9-14
For a given model, I am looking for an easy way to close all open subsystems' windows, except the basic one. If I close them all, save the model and reopen it, it works, but I want to do the same with code.

请先登录，再回答此问题。

回答（5 个）

TAB
TAB 2012-3-14
No need of using lots of variables & loop. Just find all the subsystems in the model and close them.
close_system(find_system('YouModel','findall','on','BlockType','SubSystem'));
Honglei Chen
Honglei Chen 2012-3-13
doc bdclose
doc close_system
Doug Eastman
Doug Eastman 2012-3-13
Assuming your top-level model is called TopModel you could use:
a = find_system('Parent','TopModel');
close_system(a)
Noam G
Noam G 2012-3-14
Based on Doug Eastman's tip, I came up with the following code. It closes all the subsystem except the top levels (of several systems):
Blocks_List = find_system;
Blocks_To_Close = Blocks_List;
for III=length(Blocks_List):-1:1
if isempty(strfind(Blocks_List{III},'/'))
Blocks_To_Close(III)=[];
end
end
close_system(Blocks_To_Close)
Pablo Romero
Pablo Romero 2015-9-14
There is a small trick. You can load again the top-level of the system and save it (if requested).
open_system(bdroot); % Load the top-level
close_system(bdroot, 1); % Save and close the Model
Of course you can use your Modelname instead of bdroot.

类别

在 Help Center 和 File Exchange 中查找有关 Programmatic Model Editing 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by