Different simulation results using UNC and non-UNC path

1 次查看（过去 30 天）
Gabriel Delcros
Gabriel Delcros 2017-1-27
回答： Gabriel Delcros 2017-1-30
Hello everyone,
I have an issue with my Simulink models. I try to do the same simulation with two different path : - From my local network (I:) - From a UNC path (\\simu)
I am using the same model, the same configuration and the same Matlab release (Matlab R2009a) which is supose to support UNC path and the results are not the same.
I just take a screen of different variables on the figure below:
As we can see, there is a difference of the command at t=911 which is low but produce a huge difference later like at t = 7000 which is not acceptable.
Do you have an idea why can matlab produce different simulations results?
Thank you for your attention.
Gabriel D.

请先登录，再回答此问题。

回答（1 个）

Gabriel Delcros
Gabriel Delcros 2017-1-30
up

类别

在 Help Center 和 File Exchange 中查找有关 Power and Energy Systems 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by