How do I set a flag on Simulink?

30 次查看（过去 30 天）
giancasp
giancasp 2017-2-3
回答： Dalton L'Heureux 2020-6-12
I'm trying to model a relatively simple mechanical system using Simulink, but there is a particular parameter (call it f) which seems to need computing logic that would normally require flags. Basically, if f ever exceeds a value, say 100, a separate parameter (call it s), has to evaluate to TRUE. Then, s must remain TRUE until f drops below another value, say 50. How could I go about modeling this in Simulink?
In MATLAB, the logic would go something like this, checking continuously for f:
s=0; %Initial Condition
if f>100
s=1;
end
if f<50
s=0;
end

请先登录，再回答此问题。

采纳的回答

Richard Zappulla
Richard Zappulla 2017-2-3
You can use a relay block in the Discontinuities folder. You input your signal, f, into the block and set the Switch On Point to 100 and Switch Off Point to 50 and you should be good to go.

更多回答（1 个）

Dalton L'Heureux
Dalton L'Heureux 2020-6-12
A relay block works great as already seggested. But incase anyone wants to do a similar thing using only basic logic blocks, you can define a simple latch as shown below:

类别

在 Help Center 和 File Exchange 中查找有关 Simulink Functions 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by