view([0 90]) reset by axis?

1 次查看（过去 30 天）
Peter Fraser
Peter Fraser 2017-2-4
评论： Peter Fraser 2017-2-7
I have a 3D plot that I sometimes want to view in 2D. "view([0 90])" works as expected, but a following "axis" command will reset the view direction to the default. If I change the command order it works (a fine workaround). I can follow either "view([1 90])" or "view([-1 90])" with an "axis" command, and it works as expected. What is happening?
[X,Y,Z] = peaks(25);
figure
surf(X,Y,Z);
view([0 90])
axis([-3 3 -3 3 -10 10]);
[az el] = view
gives az = -37.5, el=30

请先登录，再回答此问题。

采纳的回答

Ankitha Kollegal Arjun
This is expected behavior. When using the 'surf' command with the 'view' command and axis limits, axes view of the figure tends to depend on the order in which these commands are issued. So, as you suggested, the right way of doing things is to use the view command after the axes limiting is done.

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Annotations 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by