Need help understanding stretch-to-fit associated behavior

Question

Evan 2017-2-21

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/326167-need-help-understanding-stretch-to-fit-associated-behavior

回答： Evan 2017-3-18

Matlab documentation states that when stretch-to-fill is enabled (as it is by default), then "the axes might not exactly match the data aspect ratio, plot box aspect ratio, and camera-view angle values stored in its DataAspectRatio, PlotBoxAspectRatio, and CameraViewAngle properties." Setting the 'mode' of any one of these three properties to 'manual' should turn off stretch-to-fill. It makes sense then, that if I make a plot and then set DataAspectRatioMode to manual:

figure;plot(0.1:0.1:pi,sin(0.1:0.1:pi))
daspect manual

Then the physical appearance of the plot should change, as stretch-to-fit has been turned off and the DataAspectRatio property is now accurate. It also makes sense that if I make the same plot and set PlotBoxAspectRatioMode to manual, then the values of DataAspectRatio should change (they do), as Matlab needs to make consistent the fact that (1) I've frozen the axis lims and (2) stretch-to-fit is turned off:

figure;plot(0.1:0.1:pi,sin(0.1:0.1:pi))
daspect
pbaspect manual
daspect

However, I do not understand why if I then set DataAspectRatioMode to manual, the plot changes again:

figure;plot(0.1:0.1:pi,sin(0.1:0.1:pi))
daspect
pbaspect manual
daspect
daspect manual
daspect

In fact, if you look at the plot, the behavior is as if setting the DataAspectRatioMode to manual in this context sets the axis limits to 'tight.' Does anyone know why this happens?

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Rik 2017-2-21

I'll be interested in the answer as well. Sometimes it is difficult to see the logic behind certain behavior of Matlab, and in my experience axes and figures are the most difficult to understand.

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Evan 2017-3-18

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/326167-need-help-understanding-stretch-to-fit-associated-behavior#answer_259324

Answer is here. When LimitModes are auto while DataAspectRatioMode and PlotBoxAspectRatioMode are manual, "MATLAB chooses limits that completely fit and center the plot within the specified PlotBoxAspectRatio given the specified DataAspectRatio."