MATLAB is not showing/regenerating the figures upon pressing Run (F5)

2 次查看（过去 30 天）
Samuel
Samuel 2012-3-19
Hi all,
When I open the program and load my script file and press run or F5, it will generate the figure. However, whenever I change something and run it again, the figure will not show up or regenerate. I can save, close, reopen, and run and it will give me a new figure. Sometimes I can work for several hours and this won't happen, or, (like right now), I have to restart the program every time I change something. And being a trial and error learner right now, that is getting very annoying.
Also note, this has happened to me on two computers while running different code. Just fyi.
Thanks,
Sam

请先登录，再回答此问题。

回答（1 个）

Samuel
Samuel 2012-3-19
Someone else may be able to verify this, but would this error occur if you have a pause code, but you don't press 'enter' through all the pauses. I hope that makes sense.
Sam

类别

在 Help Center 和 File Exchange 中查找有关 Environment and Settings 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by