How do I remove a certain part of my graph?

Question

Alec Carruthers 2017-3-3

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/327843-how-do-i-remove-a-certain-part-of-my-graph

回答： Walter Roberson 2017-3-3

I'm trying to plot the specific thrust and specific fuel consumption on the same graph. I have horizontal lines that start the graph and each one goes to a different x value. I was wondering if there is a way to start the graph, for each individual curve, after the horizontal lines ends? Basically how to clean this graph up.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Walter Roberson 2017-3-3

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/327843-how-do-i-remove-a-certain-part-of-my-graph#answer_257069

You can use x values that start where the horizontal line ends.

If necessary, add the desired origin to the existing x values.

However, adding the desired origin will change what is shown with the data cursor, so if you need to have the data cursor show the offset relative to the place the curve begins rather than coordinates relative to the left edge of the plot, then you would need to take more steps.