simulink
信息
此问题已关闭。 请重新打开它进行编辑或回答。
显示 更早的评论
if i have a simulink model and the output of low pass filter is sin signal with certain frequency if i want to know this frequency and display it on a screen what should i do? remark simulation model time is (inf.)
0 个评论
回答（2 个）
K E
2012-3-22
0 个投票
I would output the signal to the workspace and calculate the frequency from within Matlab; here is an example approach. You could use Matlab to start your simulation too using the sim command, and afterward plot the spectrum that you calculate.
8 个评论
mohamed al-asklany
2012-3-23
K E
2012-3-23
In the example (http://www.mathworks.com/products/matlab/demos.html?file=/products/demos/shipping/matlab/fftdemo.html), the power spectral density Pyy is found. If you have combination of sine waves that make up your signal, Pyy should have peaks at those frequency, and your Matlab routine would identify those peaks. Expanding on the example:
Pyy1 = Pyy(1:128) ;
frequencyOfBiggestPeak = freq(Pyy1 == max(Pyy1)) ; % Hz
mohamed al-asklany
2012-3-24
Rick Rosson
2012-3-24
freq is an array of frequency values. The idea is to use logical indexing to find the frequency that corresponds to the maximum value of the power spectrum.
mohamed al-asklany
2012-3-24
K E
2012-3-26
You first need to export the simulation time and signal that you want to analyze from Simulink to Matlab using the 'ToWorkspace' block. Once these variables are in the Matlab workspace, set t equal to your simulation time variable and x equal to your simulation signal (for example position). Once you have t and x in your Matlab workspace, follow the example (http://www.mathworks.com/products/matlab/demos.html?file=/products/demos/shipping/matlab/fftdemo.html) to obtain freq and Pyy. Then you can find the peak using the code that I supplied earlier:
Pyy1 = Pyy(1:128) ;
frequencyOfBiggestPeak = freq(Pyy1 == max(Pyy1)) ; % Hz
mohamed al-asklany
2012-3-27
K E
2012-4-4
You could decide how much time you would need to get a good estimate of the frequency (for example, 30 periods of a 10-second sine wave would be 300 seconds), then put an event listener (http://www.mathworks.com/help/toolbox/simulink/slref/add_exec_event_listener.html) in your model that would output the results to the workspace at 300 seconds.
Sivakumaran Chandrasekaran
2012-3-24
0 个投票
I think you can use the option named display which is available in sink block.. I am not sure also whether this will work or not.
1 个评论
mohamed al-asklany
2012-3-24
此问题已关闭。
2012-3-22
关闭：
2021-8-20
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
