I have this error but don't know what it means. Model is configured to implement operator (strip)fx. PLC Coder does not support this operator.

Question

SXO 2017-3-22

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/331294-i-have-this-error-but-don-t-know-what-it-means-model-is-configured-to-implement-operator-strip-fx

评论： SXO 2017-3-30

I'm trying to build structured text using the PLC Coder. Usually if there is an error, there will be a link to take you to the source of the error. But in this case, there is no link, just a cryptic message.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Jyotish Robin 2017-3-30

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/331294-i-have-this-error-but-don-t-know-what-it-means-model-is-configured-to-implement-operator-strip-fx#answer_261007

Hi!

I had faced similar error when trying to build structured text using the PLC Coder. I was able to get rid of the errors by changing the value of a constant block from single data type to double.

Maybe this will help you resolve the error.

Regards,

Jyotish

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

SXO 2017-3-30

Thanks! I found one location where I was using a data conversion block to force the signal to a single data type. When I removed the block, the error went away.

SUNIT.

请先登录，再进行评论。